SubLVDS to MIPI CSI-2 Image Sensor Interface Bridge Soft IP
Many Image Signal Processor (ISP) or Application Processors (AP) use the Mobile Industry Processor Interface (MIPI® ) Camera Serial Interface 2 (CSI-2) standard for image sensor inputs. However, some high resolution CMOS image sensors use a proprietary SubLVDS output format. The Lattice Semiconductor SubLVDS to MIPI CSI-2 Image Sensor Interface Bridge IP for Lattice Semiconductor CrossLink™ solves the interface mismatch between subLVDS output image sensor and an ISP/AP using MIPI CSI-2 interface.
Download this whitepaper to find out more.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Communication, Image sensors, Power, Processors
More resources from Lattice Semiconductor Corporation
Pre-tested System-on-Chip Design Accelerates PLD Development
Many moderate size Programmable Logic Device (PLD) designs, especially those in control plane applications, consist of a number of interfaces inter...
POWER CONSIDERATIONS IN FPGA DESIGN
Power has always been a design consideration. Traditionally, though, a lower priority has been assigned to power than to most other variables (spee...
Intellegently Expanding Microprocessor Connectivity Using Low-cost FPGAs
Whether they be CPUs, micromicroprocessors or microcontrollers, microprocessors are an indispensable component in modern electronic system design. ...
