Inductors
Synchronous Rectification for Forward Converters
In many switching power converters, rectifier diodes are used to obtain the DC output voltage. The conduction...
Advantages and Challenges of Third-Overtone IC Crystals
ICs with on-board oscillators requiring low frequency fundamental crystals are commonplace but now IC...
Ultra Low Noise Amplifiers
This white paper describes the performance and characteristics of two new ultra low noise LNAs from Skyworks....
Medical power supplies: trends, challenges and design approaches
Medical electronic equipment is getting smaller. Of course, this could be said of all electronic equipment...
Powering your FPGA Applications
Field-programmable gate arrays (FPGAs) have gained much attention and widespread application in the end...
Tips and Tricks on How to Verify Control Loop Stability
In a design of a modern switch-mode power supplies (SMPS), the designer has to ensure that the converter...
eGaN® FET Small Signal RF Performance
Even though the eGaN FET was designed and optimized as a power-switching device, it also exhibits good...
Optimise beamforming: From bits to RF beams
Radar, satellite communications and 5G NR use AAS with phased array antennas for beamforming. Hybrid...
Material Advances Enable New Generation of Power Inductors
Designers building power inductors for today's highly volume mobile markets face a difficult dilemma....
Optimizing EMI Input Filters for Switched Mode Power Supplies
Almost every switched-mode power supply (SMPS) needs an EMI (Electro Magnetic Interference) input filter...
Sign up for Electronic Pro Tech Publish Hub
As a subscriber you will receive alerts and free access to our constantly updated library of white papers, analyst reports, case studies, web seminars and solution reports.